Installation duo
15
Installation option A/B
• Choose a suitable location for the installation of the control housing
(1), preferably near a power socket (3).
Minimum height from the floor: 1,6 m.
Please note when selecting location of control unit housing (1)
that the maximum length of the control cable (2) is 6900 mm and
no longer!
• Install the control line (24 V) (2) to the control housing (1) in the
garage. Do not yet plug in the power plug (4)!
• Mark fixing points horizontally 110 mm apart on the wall. Drill two
holes (Ø 10 x 65 mm). Insert wall plug (1) into the holes in the wall.
Be careful not to drill into the socket outlet feeder and do not
plug the mains plug in yet!
• Loosen the strain-relief (1) device at the rear of the control unit.
Insert the end of the control cable (2) into the rear of the control unit
(1). Use the strain-relief (1) device to protect the power cable (3) and
control cable (2).
• Connect the control cable (2): connect the core marked 3 (green) to
terminal 3 and the core marked 4 (red) to terminal 4 of direct socket
unit (1). Shorten the control cable (2) if necessary.
In the case of swing doors, connect wire marked 3 (green) to
terminal 4 of the direct socket unit (2) and the one marked 4 (red)
to terminal 3.
• Secure the control housing (1) to the wall, using the two screws (2).
Align the control housing (1) and secure it with screws.
27
26
• Slot the control board (1) into terminal bar (2) and slide it into the
housing.
• Mount the lamp hood (2) and tighten the screw (3).
Installation option C
• Choose a suitable location for the installation of the control housing
(1), preferably near a power socket (3).
Please note when selecting location of control unit housing (1)
that the maximum length of the control cable (2) is 6900 mm and
no longer!
• Install the control line (24 V) (2) to the control housing (1) in the
garage. Do not yet plug in the power plug (4)!
• Drill 4 holes (Ø 6 x 40 mm deep). Place plugs (2) in holes. Included
in delivery. Supplied components 2 plugs, 2 screws.
Be careful not to drill into the socket outlet feeder and do not
plug the mains plug in yet!
• Loosen the strain-relief (1) device at the rear of the control unit.
Insert the end of the control cable (2) into the rear of the control unit
(1). Use the strain-relief (1) device to protect the power cable (3) and
control cable (2).
• Connect the control cable (5): connect the core marked 3 (green) to
terminal 3 and the core marked 4 (red) to terminal 4 of direct socket
unit (2). Shorten the control cable (5) if necessary.
In the case of swing doors, connect wire marked 3 (green) to
terminal 4 of the direct socket unit (2) and the one marked 4 (red)
to terminal 3.
26
25
Komentarze do niniejszej Instrukcji