
37
2. While on any maintenance screen, press and O simultaneously. The controller will display the Configuration
menu.
3. To save any changes and exit the Configuration menu, press and hold for five seconds. To cancel any changes
and return to the maintenance screen, press and hold O for five seconds.
SET THE CONTROLLER CLOCK
The schedule runs based off the time set in the controller clock. Use the following procedure to set the controller
clock BEFORE setting the schedule:
1. Navigate to the Maintenance group and press ► to access it.
2. Press ► to select the Time section.
3. Set the time and date to the correct local time.
SET THE SCHEDULE
1. Access the Scheduler group by pressing the ► button.
Note: The Scheduler group is made up of the Scheduler Options and Scheduler Setup sections. Each section can
be accessed and exited using the ► and ◄ buttons.
2. Access the Scheduler Options section. Within this section, the scheduler can be enabled, run mode selected,
and load mode selected.
3. Access the Scheduler Setup section. Within this section, each schedule entry can be modified by pressing the
button to select the item and the ▲ and ▼ buttons to define them.
Note: The controller must be in Auto mode to run at the programmed time. Use a trickle or solar battery charger to
prevent the controller from draining the battery while in Auto mode.
SET THE UNIT TO AUTO MODE
1. From any operator or maintenance screen, press and hold the Auto/Manual Mode button for five seconds, or
until Auto mode is displayed at the top of the screen.
Note: If any of the scheduled time slots are currently active, the controller will begin the starting sequence and start
the unit provided there are no shutdown conditions present.
Item Values
Enable Yes/No
Run Mode Monthly/Weekly
Load Idle, In Island, On Load, Off Load
Item Values
Schedule Entry 1-16
Start Time 00:00-23:59
Duration 00:00-99:59
Day Monday-Sunday
Week (of month) First, Second, Third, Fourth
Komentarze do niniejszej Instrukcji